]> http://www.4m-net.org/taxonomy/term/957/0 en http://www.4m-net.org/KnowledgeBase/papers/2008/05-03 <p>K. Liu, J. Peirs, E. Ferraris, B. Lauwers, D. Reynaerts<br /> Afd. PMA, Department of Mechanical Engineering, Katholieke Universiteit Leuven, Leuven, BE-3001, Belgium</p> <h3 >Abstract</h3> <p>The Electrical Discharge Machining (EDM) behaviour and machining properties of advanced engineering Si3N4-based ceramic composites Si3N4-TiN are investigated and discussed in this paper. Two types of EDM machining configurations, micro-EDM milling and die-sinking EDM, are employed in the investigation. Relaxation type of pulse is used, and the performances of EDM process in the form of material removal rate, tool wear and surface quality are studied. These tests result in a performance comparison and a discussion on the ceramic composites material removal mechanism. The feature of material removal mechanism is characterised as chemical decomposition of Si3N4 and TiN at elevated temperature rather than melting/evaporation. The generation of nitrogen gas bubbles leads to a porous and foamy top surface structure. Due to the ideal mechanical and physical property of Si3N4-TiN ceramic composites, an application example - a turbine impeller -<br /> as a crucial component in a micro power generation system is manufactured with obtained knowledge in both<br /> machining configurations.</p> Ceramic composites ceramics Electrical discharge machining (EDM) Micro Electrical Discharge Machining Si3N4-TiN Wed, 30 Jul 2008 13:29:52 +0100