micro-fluidics

C.A. Griffiths (1), S. S. Dimov (1), E.B. Brousseau (1), C. Chouquet (2), J. Gavillet (2), S. Bigot (1)

(1) Manufacturing Engineering Centre, Cardiff University, Cardiff CF24 3AA, UK
(2) French Atomic Energy Commission (CEA), Laboratory of Innovation for New Energy Technologies and Nanomaterials (LITEN), 38054 Grenoble, France

Abstract

Micro injection moulding as a replication method is one of the key technologies for micro manufacture. The understanding of process constraints for a selected production route is essential at both the design stage and during mass production. In this research a tool surface treatment is used to study the effects of demoulding a part with micro features. In particular a tool coated with diamond like carbon (DLC) will be compared to an identical tool without coating. Through a range of experimental trials the effects of four process parameters, namely melt and mould temperature, and cooling and ejection time will be used to evaluate the demoulding process. Using two polymer materials PP and ABS, a special attention is paid to the forces present in demoulding and conclusions are made about the influence of DLC surface treatments and the factors affecting demoulding.

D. Clausi, J. Peirs, D. Reynaerts
Katholieke Universiteit Leuven, Department of Mechanical Engineering, Division PMA

Abstract

Shape Memory Alloys have a considerable potential for integration into microsystems, where scaling down of their size allows favorable exploitation of the intrinsic adaptive capabilities, providing an actuation mechanism for applications (e.g. micropneumatics) requiring large force control and large actuator stroke. However, the implementation of these materials into actual structures is rather complex and mostly confined to depositing thin NiTi films onto certain target substrates, resulting in devices having a relatively high cost-per-piece. This paper is aimed at investigating a novel approach for batch integration of SMA to microactuators, which might provide a cost-effective alternative to thin film technology while enhancing functional properties and design flexibility. Indicative requirements for the actuator design have been drawn from typical microvalve applications. In order to evaluate the actuator performance, brass microcantilevers have been produced, with prestrained SMA thin wires bonded on top of them, eccentrically with respect to the cantilever’s neutral plane. The activation of SMA element is obtained by direct heating through electrical current. The bending actuation of the cantilever leads to large strokes, expected to match the requirements of a wide range of applications.