4M Knowledge base - papers

A Friction Model for Microforming

H.J. Jeon, A.N. Bramley
Department of Mechanical Engineering, University of Bath, Bath BA2 7AY, UK


For the simulation of metal forming processes, input data relating to the tool-workpiece interface is necessary. For microforming applications the tool/workpiece interface conditions tend to dominate the process and it has been found that traditional methods of modeling the interface are not realistic. This paper describes an approach that seeks to describe friction by modelling the geometric surface roughness of the tool as opposed to the use of the traditional empirical friction coefficient or factor. This finite element based model has been validated experimentally in terms of loads and metal flow using the ring test and actual surface measurements. It enables more accurate and also more flexible modeling of friction. As such it will be very suitable for microforming applications.

Submitted on May 19, 2008 - 15:23.

minam fp6
Copyright© 4M Network of Excellence.